The ConnectIT Mount Plate for the Tobii Dynavox T10 is easy to install. All you need to do is remove the screws from the back of your T10, position the mount plate, and then attach it using the two Phillips screws provided.
Included with the Connect IT Mount Plate are:
- Hex-head Allen wrench
- Two Phillips screws
Remove the Screws from the Back of the T10
Using the hex-head Allen wrench included with the mount plate, remove the two screws from the back of your T10.Note: If you have previously attached the handle that was included with your device, you will need to remove it in order to use the mount plate.
Position the Mount Plate
Position the mount plate on the back of your T10 as shown in the illustration below. Line up the screw holes in the T10 with the screw holes in the mount plate.Note: If the plate is positioned correctly (i.e., right-side up), the screw countersinks will be facing upward, and the notch at the top of the plate will be oriented to the left.
Attach the Mount Plate
Using a Phillips screwdriver (not included with the mount plate), screw the two provided Phillips screws through the holes in the mount plate and into the device.Note: The specifications of the Phillips screws are: 8-32 x 1/2" flat-head machine screw, black oxide with NyLoc (Tobii Dynavox part # 140381).